Light curing molding technology (SLA) is a rapid prototyping technology that first appeared and realized commercialization in the world, and it is also one of the most in-depth and widely used rapid prototyping technologies. It mainly uses photosensitive resin as a raw material, and utilizes the characteristic that liquid photosensitive resin will cure quickly under ultraviolet laser beam irradiation. The photosensitive resin is generally liquid, and it immediately initiates a polymerization reaction and completes curing when irradiated with a certain wavelength of ultraviolet light (250 nm to 400 nm). SLA focuses on the surface of the photocurable material by using ultraviolet light with a specific wavelength and intensity to solidify it sequentially from point to line and line to surface, thereby completing the drawing of a layered cross-section.
SLA process printing process
1. Control the printing screen to sink to a certain height below the resin surface, so that the screen is covered with a layer of material.
2. The computer controls the laser and galvanometer, and uses UV laser to scan the cross-section of the part currently to be printed, and solidify the part of the material that needs to be printed from liquid to solid.
3. After the scanning is completed, the screen sinks to a certain height, the scraper spreads a layer of material (the main function is to scrape and fill the large flat material), repeat the above step 2 until the printing is completed.
4. After the printing is completed, take out the printed product, which needs to be cleaned with absolute ethanol and cured by ultraviolet light.
Characteristics of SLA process
The printing material of SLA is a liquid resin. During the curing process, the monomer carbon chains that make up the liquid resin will be activated by the UV laser and become solid, thereby forming a strong and indestructible bond between each other. The photopolymerization process is irreversible, so SLA parts cannot be converted back to a liquid state, and they burn rather than melt when heated.
The height of the printing layer in the SLA process is between 25 and 100 microns. Lower layer heights can more accurately capture curved geometries, but will increase build time (and cost) and the possibility of printing failures. A layer height of 100 microns is suitable for most common applications.
The construction area is another parameter that is very important to the designer. The build size depends on the type of SLA machine. Bering 3D's supply chain system has almost all types of SLA equipment on the market, with full coverage of construction area (print size) and printing materials.
Support structure of SLA process
SLA's printing process principle determines that a supporting structure must be required during the printing process. The support structure is printed with the same material as the part and needs to be removed manually after printing. The direction in which the part is printed determines the location and number of supports. Print placement is to properly orient the parts so that the visual critical surface does not contact the supporting structure.
The bottom-up and top-down SLA printer usage support methods are different:
In top-down SLA printers, supports are required to accurately print overhangs and bridges (the critical overhang angle is usually 30 degrees). Parts can be oriented at any position, but different orientation methods will result in different printing time and product quality. They are usually printed in a flat shape to minimize the amount of support and the total number of layers.
In bottom-up SLA printers, the situation is more complicated. Overhangs and bridges still need to be supported, but minimizing the cross-sectional area of each layer is the most critical consideration. The force applied to the part during the peeling step may cause the part to detach from the build platform. These forces are proportional to the cross-sectional area of each layer. Therefore, the parts are oriented at an angle and reducing support becomes a major problem.
Advantages of SLA process
(1) SLA can produce parts with high dimensional accuracy and complex details.
(2) SLA parts have a very smooth surface finish, making them ideal for visual prototypes.
(3) Special SLA materials can be used, such as transparent, flexible and castable resin.